Generator exhaust
My exhaust pipe on my onan 2500 generator exhausts right under my slide out. I need to route the exhaust pipe to exit the other side. The pipe is 1 1/8 od . I'm going to try to use some 11/4 id green...
Forum Discussion
trail-explorer wrote:Jim@HiTek wrote:
I used electrical unions and plastic PVC to route my exhaust
Plastic exhaust pipes..... uhhh.....
not sure what to say about that.
No need to say anything, check out the link I posted of the commercial product that uses plastic pipe to vent the generators exhaust above the roof line. It's been available for a couple decades now. Note that the way it's set up is to mix cooling air with the exhaust so it's not hot enough to melt the plastic pipe. And that's how I set mine up. Copied their design with available hardware products.
