Help! Foolish me playing mechanically inclined again.
Tried, most correctly described, to put the upper overload Stableloads on my new truck today. Beautiful weather for it here.
Well, to make this short, I cannot get one of the factory nuts off for one of the rear factory upper overload pads.
Suppose if I had used a six point socket instead of a 12 point, things would be better. But appears I rounded the nut off some, and no matter what tool I used, no good.
Any tricks or suggestions for getting off that slightly rounded nut??? There's not a whole lot of room to work in that location.
Thanks.
Well, to make this short, I cannot get one of the factory nuts off for one of the rear factory upper overload pads.
Suppose if I had used a six point socket instead of a 12 point, things would be better. But appears I rounded the nut off some, and no matter what tool I used, no good.
Any tricks or suggestions for getting off that slightly rounded nut??? There's not a whole lot of room to work in that location.
Thanks.
