Question about standard jack practice
I have a question about how you all raise your jacks to prevent binding during the process. Since each jack motor seems to run at a different speed, it seems guaranteed that at some point in the proc...
Forum Discussion
Super_Dave wrote:
What I notice and not sure what causes it, is the binding jack needs to be raised off the ground and you can see it move laterally just a bit. If the feet touch the ground vertically to begin with, I'm not sure how the load moves horizontally on what is virtually a level surface. I was presumming it was the difference in jack speeds.
that sounds more like the jack is out of square with the tc and the other jacks
