Removing a B&W gooseneck from F-250
Looking at a used 250 with the B&W gooseneck setup. I know how to remove most of the hardware but is there some neat and simple way to cover the hole in the truck bed? Anyone else done this?
Forum Discussion
Understood.
Go to Amazon and search "gooseneck hole cover" and "gooseneck hole plug". There are several available. But like I said, depends on how nicely that hole was cut.
Most beds already have a nice flat spot there (corrugations flattened out specifically for this reason). So you could simply cut a flat cover piece, paint it, and screw it in place. It would end up below the level of corrugations, and would look pretty decent I think.
Go to Amazon and search "gooseneck hole cover" and "gooseneck hole plug". There are several available. But like I said, depends on how nicely that hole was cut.
Most beds already have a nice flat spot there (corrugations flattened out specifically for this reason). So you could simply cut a flat cover piece, paint it, and screw it in place. It would end up below the level of corrugations, and would look pretty decent I think.
