Forum Discussion

sonuvabug's avatar
sonuvabug
Explorer
Jul 18, 2022

Sealing my TC's EPDM Roof

I tried searching for a thread using every combination of words I could think of with no real luck.

I want to seal my EPDM roof with the best product based on people's experiences. I keep my 2007 TC's roof clean and it is in good shape for it's age but I feel it's time to put a protective coat on it.

I've spent hours on YouTube reviewing clips spouting the merits of all of the usual suspects (Dicor 2-part system, Flex Seal, Henry Silicone RV roof sealant, others etc.) More confused now than ever.

Any recommendations based on first hand experience/ or can you direct me to a thread where this has been already thoroughly covered. Thanks.
  • There's a company here in Houston that will remove your old rubber EPDM roof and replace it with a spray on bedliner type product, which is nearly indestructible. When my roof gets old enough to need repairs, that's what I'm going to do. And their pricing was unbelievably LOW compared to doing another rubber roof. You should see if there are people in your area that offer that service.
  • I would like a product that perhaps could spray over the EPDM and make the rain a little quieter. Off topic but I wonder...
  • If your spray on bedliner leaks into your truck bed, you don't know or care.

    Nobody tosses heavy tool boxes or cinder blocks onto, or drags chains across their camper roof.

    I would stick with a product designed and proven for the application. There is no better product for a low-slope roof than EPDM.
  • rhagfo's avatar
    rhagfo
    Explorer III
    wanderingbob wrote:
    HENGS
    Heng’s

    I used as well and really like it. Scrubbed roof with Tide powdered detergent first rinsed well then applied the next day, two thin coats per instructions.
  • Hemi Joel wrote:
    If your spray on bedliner leaks into your truck bed, you don't know or care.

    Nobody tosses heavy tool boxes or cinder blocks onto, or drags chains across their camper roof.

    I would stick with a product designed and proven for the application. There is no better product for a low-slope roof than EPDM.


    It's a spray on bedliner "TYPE" product, as in something that sprays on thick. Not necessarily bedliner.
  • Hemi Joel wrote:
    I am a commercial/industrial roofing contracor. We have installed millions of square feet of EPDM on flat roof buildings over the last 40 years. Believe me, you do not need to coat EPDM. A good EPDM will last over 30 years before it starts to break down. The problem with an RV roof is the penetrations. If I flashed commercial roof penetrations the way RV manufactures do, I'd be in prison. So maintain your penetrations. Do not let any cracks go, inspect often, do not let any water get under your roof. Water under the roof breaks down the surface of the underlayment and the bond to the EPDM will be lost. Dicor works fine at keeping up on them. The biggest enemy of EPDM is oil. Do not repair it with asphalt plastic cement, or anything oily, and do not clean it with anything oily. It is not necessary to clean your roof, but if you feel like you want to just because, use mild soap and water. I have 35 year old roofs that have never been cleaned. But DO scrub the repair areas clean with soap and water and a scotchbrite pad before applying the Dicor, this will help it stick.


    Is the commercial EPDM the same thickness as what is on most RVs?
  • The most common thickness in commercial is 60 mil, which is .060 in thick. It is also available in 45 mil and 90 mil. I'm not sure what thickness they use on an RV.
  • Hemi Joel wrote:
    The most common thickness in commercial is 60 mil, which is .060 in thick. It is also available in 45 mil and 90 mil. I'm not sure what thickness they use on an RV.


    mil mm inch

    60 1.524 0.06 1/16 in