Hey, all. Thank you for replying, and apologies for going silent this week. Bogged down with work. Very new to this, so appreciate the guidance and advice. I've attached some photos of the camper tie down points (one on each corner of the camper) and the bed of my truck. It's on jacks in my driveway at the moment while I wait to get some suspension upgrades in my truck next week. Once the airbags are in, it will go in my truck for summer adventures, but again, very new to this, so looking for advice from people more in the know. Thanks again!
Is the camper/tie downs wide enough to clear the bedsides?
If so then maybe happijac mounts would work?
If too narrow, I don’t see any decent tie downs in the plastic Taco Swiss army bed sides.
First see if/who makes any mounts for a super short box Taco and go from there.
Everything is currently pointing toward Tork Lifts installed front and rear and tying it down from there. The camper is just wide enough to clear the bedsides but I went in to a trailer/RV shop this weekend and they were pretty certain that Tork Lift is the best option. Bummer since it's so expensive but it is what it is.
