Wolf Creek 850 roll over story
Well, Since I opened this can of worms here is the entire story.
First let me say I have been a long time truck camper owner and I am no rookie. I have gone trough several truck campers. I recently had an article published in truckcampermagazine.com about me and my family
Here is some more background on who I am and how long I have been truck camping.
http://www.truckcampermagazine.com/camper-lifestyle/four-season-truck-camping-in-southern-california
If you read the article you can see in the pictures I used the same tie down system with both the Northstar Laredo and Eagle Cap 800.
The week before Christmas I was driving home from a great camping trip in the anza borrego desert (trip report here http://www.anzaborrego.net/anzaborrego/Forum/messages.aspx?TopicID=694 and was traveling on BLM land road named EC085. I was traveling at approx 25 mph on a straight section of the road, when a strong gust of wind came up and caused the camper to become separated from my truck and rolled over the truck bed rail! The road was also a bit bumpy but not too bad. I had my 6 year old son Brett and 8 year old daughter Brenna in the truck with me. It is a miracle we are all okay. The crazy part of the situation is I did not really feel the truck do a huge sway or anything. It was my daughter in the backseat who said "dad the camper just fell off". Upon further inspection I noticed the cause of the camper becoming separated from the truck was my Wolf Creek was manufactured with a spliced in piece of plywood where the front passenger anchors are installed and this spliced plywood separated from the skirt. When the front tie down became separated I noticed my bumper was tweaked a bit upward and believe the rear tie down became separated by pulling up on my bumper. Before starting to travel on EC085 I called my wife to tell her we were going to stay one more night. Knowing I was about to be driving about 20 miles on a dirt road I specifically checked all my spring loaded turnbuckles to make sure they were nice and hand tight snug. I am fully aware of keeping the turnbuckles hand tight and not using a tool to tighten them down.
Here are some pics from the incident
The spot where I called my wife took a pic and checked the tie downs
The spot where the camper rolled out
My wolf creek in the middle of the desert. Notice the turnbuckle still attached
closer look at splice
My truck
The torn off jack
Underside separation
Nose cap damage
rescued by Dickerson Towing
Moderator edit: Please note, maximum photo width=640.
First let me say I have been a long time truck camper owner and I am no rookie. I have gone trough several truck campers. I recently had an article published in truckcampermagazine.com about me and my family
Here is some more background on who I am and how long I have been truck camping.
http://www.truckcampermagazine.com/camper-lifestyle/four-season-truck-camping-in-southern-california
If you read the article you can see in the pictures I used the same tie down system with both the Northstar Laredo and Eagle Cap 800.
The week before Christmas I was driving home from a great camping trip in the anza borrego desert (trip report here http://www.anzaborrego.net/anzaborrego/Forum/messages.aspx?TopicID=694 and was traveling on BLM land road named EC085. I was traveling at approx 25 mph on a straight section of the road, when a strong gust of wind came up and caused the camper to become separated from my truck and rolled over the truck bed rail! The road was also a bit bumpy but not too bad. I had my 6 year old son Brett and 8 year old daughter Brenna in the truck with me. It is a miracle we are all okay. The crazy part of the situation is I did not really feel the truck do a huge sway or anything. It was my daughter in the backseat who said "dad the camper just fell off". Upon further inspection I noticed the cause of the camper becoming separated from the truck was my Wolf Creek was manufactured with a spliced in piece of plywood where the front passenger anchors are installed and this spliced plywood separated from the skirt. When the front tie down became separated I noticed my bumper was tweaked a bit upward and believe the rear tie down became separated by pulling up on my bumper. Before starting to travel on EC085 I called my wife to tell her we were going to stay one more night. Knowing I was about to be driving about 20 miles on a dirt road I specifically checked all my spring loaded turnbuckles to make sure they were nice and hand tight snug. I am fully aware of keeping the turnbuckles hand tight and not using a tool to tighten them down.
Here are some pics from the incident
The spot where I called my wife took a pic and checked the tie downs
The spot where the camper rolled out
My wolf creek in the middle of the desert. Notice the turnbuckle still attached
closer look at splice
My truck
The torn off jack
Underside separation
Nose cap damage
rescued by Dickerson Towing
Moderator edit: Please note, maximum photo width=640.
