3d printed water fill adaptor
I use my 3d printer to create accessories and replacement parts. I designed a water fill adaptor so that the water hose wont keep falling out as I fill the fresh water tank. If you have a 3d printer, ...
Forum Discussion
I wish I knew correct terminology, it would make a response much easier. I tried the one 2112 showed above, but it wouldn't work on my fill hatch without modification. My camper uses a hatch that looks like this one:
Clicky
Taking material off of the portion labeled in red didn't help. I finally chalked the locking portion of the hatch on the camper and put the adapter against it. It appeared that the locking flange on the adapter was too close to the cap of the adapter (sorry again for poor terminology). I took a brass wire brush in a dremel and removed some of the inside of the locking flange, and was able to get it to go on. I can't test it yet as it is too cold here to be dealing with water and hoses, but I think it's going to work.
Clicky
Taking material off of the portion labeled in red didn't help. I finally chalked the locking portion of the hatch on the camper and put the adapter against it. It appeared that the locking flange on the adapter was too close to the cap of the adapter (sorry again for poor terminology). I took a brass wire brush in a dremel and removed some of the inside of the locking flange, and was able to get it to go on. I can't test it yet as it is too cold here to be dealing with water and hoses, but I think it's going to work.
