Installing stabilizer quick release brackets
Because our driveway is so steep we need to remove the tongue jack and rear stabilizers every time we go into or out of our driveway (even after lifting th trailer). We did this by removing and insta...
Forum Discussion
I was going to move them forward, but we have a rear slide and end up with a lot of weight past the bumper when setup. I wanted to keep our stabilizers set back to the rear because of that. Even after the lift and 2x10's at the entrance of the driveway our bumper clears by
copeland343 wrote:
It looks like a great mod. Also it sounds like you stabilizers were mounted to close to the ends of you RV. Look at page 3 of mounting instructions. I moved ours to the correct location (mounted to far back from MFG.)and now no clearance problems.
http://norcoind.com/bal/downloads/manuals/Leveling%20Scissors%20Jack%20Manual.pdf
