Anyone modify their BW Hitch release arm?
I have a 2009 F-450 DRW and I stand about 5'8". The only way I can remove the pin and open the jaws on my BW hitch is with a step stool. I was wondering if anyone has done any mods to make it easier...
Forum Discussion
dedmiston wrote:I have some but can't figure out how to get them here, they are on my IPhone and computer. I don't have any on line hosting service either.Vette Racer wrote:
I had the same problem even though I use a milk crate to stand on, my solution was to drill a couple of holes on the release arm and installed a long flat steel bar to the arm so it extends almost to the bed rail, mounted six rectangle magnets on the bar and took a piece of 1/4 inch round steel, bent it 4 inches in to form a ninety degree end that goes through the locking hole and it lays on the magnets to keep it in place and can be used to reach the hole for locking the arm open as well.
Those dually fenders, especially on the Ram makes it hard to get to anything while standing outside the bed, even on a step, when you're short and fat and old. LOL
Do you have any pictures of this?
