Bearings and bad decisions......
A cautionary tale of wheel bearing tragedy.... Learn from my bad decision.... I was doing my pre-trip walk around this morning as we prepared to get back on the road. I noticed a missing wheel bea...
Forum Discussion
fj12ryder wrote:
The grease comes out the front cap around where you putting in new grease. Obviously if you're not seeing any grease coming out there's a problem. Works great, I've used it a couple times over the 10 years we've had our toyhauler and have had no issues. The bearings looked good when I pulled them last year.
Thanks . Have always wondered ,because the old grease is supposed to get pushed out of the bearings ,and the new going in .That old grease has to go somewhere.
I am just too old school I guess. Done it for years, hand packing my bearings.
I just may try it , jack a wheel up ,and spin it ,and see for myself if that old grease comes out the front where its supposed too, have always been a little skeptical . In all honesty I should have read the dexter manual on doing it, and would of at least known where the old grease is coming out . Thanks again for being gentle on me for not reading the manual . :)
