Factory wired Satellite
I purchased a 5th wheel trailer and needed info on how to install my Winegard Traveler. The 5th wheel is a used 40'2013 Heartland Landmark Key Largo and is Factory wired for Satellite. I installed th...
Forum Discussion
Michelle.S wrote:
Don't know about the LandMark, but our Redwood was pre-wired. Which means you undo the little plate on the roof where there are one or two coax connectors and pull out the Winegard control cable to connect to the Travler. The other end is in a bedroom cabinet in out unit for mounting the Winegard control head.
Ours is a Single Wire unit, so the power inserter and splitter are all mounted in the cabinet with the control head.
Our Cedar Creek was almost identical.
We had a cut here sticker on the roof and a plate in the small cabinet in the bedroom. Removed the plate and found the power cable that runs from the control box to the Trav'ler.
On the roof found the sticker and said a prayer and cut a hole in my roof, inside was the other end of the power wire for the Trav'ler and 2 color coded coax cables with no ends.
Spent some time positioning the dish marked it all off with a sharpy and Dicored. Placed it back and by HAND screwed the trav'ler down.
Dicored it all again hooked everything up and wala.
Reprogramed the 211z and then later started using the Hopper2 from the house. (Had to install a "solo node".
