Good installer for Disc Brakes ?
I'm considering switching from drums to disc brakes on my 2013 Bighorn. I full time so I can get it done anywhere, but would prefer Florida because I spend winters there. But I have absolutely no prob...
Forum Discussion
jshupe wrote:
Nice. I decided I'm going to be ordering from him and doing a DIY install. Just need to run down to the storage lot and find if I have 1/2" or 9/16" studs and then I'll get them ordered.
I did my own install a few weeks ago, pump and discs from Southwest Wheel. I used hard steel lines, mostly from etrailer but some from local auto supply. etrailer sells a 66 inch line to match the I-beam spacing for the crossover line. Bleeding the brakes is an ez one person job. With a switch, 20 ft of wire and alligator clips you can remotely control the pump.
