Hitch Pin Movement

Passin Thru wrote:
You need to bush the hole and buy a new hitch reciever. Or replace the whole hitch. Eventually it will break off.

I say new hitch to be sure. Moving pin indicates it is not sturdy and stable enough. Happened to one guy here, he brought his truck to the shop for new tires and forged wheels installation. The pin on his hitch has been moving and almost break at the slight elevated towing.

You need to stop the movement of the receiver from going side to side. You probably found out the angled pin will work it's way into the hole as the receiver goes side to side eventually elongating the hole in the hitch. Especially if your using friction sway bars.

I had to replace the hitch (good time for a upgrade) and then went with the Hitchrider. This will stop all movement and easy to install.

I would also recommend not using the angled pin or even the locking pins with cheap Chinese locks and go with just a 5/8" bolt with large flat washers and a Nylock nut.
http://www.hitchrider.com/hitch-vise-gm-2.htm

You guys need to try towing with a Pintle Hitch and Lunette Eye... Thats some real slop there...lol

Maybe this can help?

Tune your balls

Can you post some photos?

Not enough hitch weight causing the hitch to rattle in the reciever.

You need a good anti rattle device so you don't get so much play in the receiver.

I have tried almost every Anti Rattle device on the market, most have been no good or so complicated and cumbersome that they are useless. Including the Roadmaster type,totally useless.
Until I found the one at Hitch Rider.

Their Hitch Vice is the best and easiest one I have come across and it really works.

If I am understanding your question, maybe this would work....Anti-Rattle Hitch Pin.

LINK...CLICKY

You need to bush the hole and buy a new hitch reciever. Or replace the whole hitch. Eventually it will break off.

I can't picture what goes wrong. I've been towing for decades without any issues like that. What is their failure mode?