mystery wire on 2006 Weekend Warrior FS2600

its a auto reset to your 12volt panel

I hate to sound so ignorant, but what is my 12v panel and what does an auto reset do?

Mike

After doing a little research it looks like the auto reset is something that performs like a circuit breaker that continuously trips and resets while an over current event is taking place? And I am guessing that the 12v panel is the strip where all my fuses are located? What would you estimate the amperage for this to be? I can't read anything on the auto reset.

Thanks for getting me, on I hope, the right trail.

Mike

you are correct and look on the bottom of it should see numbers stamped on it

Thanks again for your help.

Mike

I had trouble with the inline fuse near my battery box on my '05 FS2600. I ended up removing the fuse and running a new (much bigger) line from the battery to the main panel. Never had any trouble again.

Did you take the auto reset out of the circuit all together and just run larger wire?

Mike

mikeof6 wrote:
Did you take the auto reset out of the circuit all together and just run larger wire?

Mike

DON'T DO THAT! this circuit breaker has a definite purpose. You can substitute a fuse or manual reset breaker but leave something in the circuit to protect the panel and battery

I wasn't going to do that but I was curious if dedmiston did that. Thanks for your concern, I appreciate it.

Mike

Mine was just a small blade fuse. The fuse would never burn out, but the wire would get hot all the time, finally hot enough to burn the fuse holder and the flimsy wire on either side of it. I think we owned the trailer for another five years or so after I ditched the inline fuse and put in the beefier line.

I can't remember what size the fuse was now, but I remember being astonished at (A) how small the fuse was, and (B) the fact that the fuse never blew, even though the whole thing fried itself.

It sounds like y'all are saying that the fuse had a purpose, other than to catch itself on fire. :B