Class C Cabover Rebuild
Hello all! I am new here but have been looking around for quite a while. My wife and I purchased a used class c, 1992 Jamboree Searcher by Fleetwood. I thought I had looked the rig over good and my wi...
Forum Discussion
DaHose: what did you use to glue your skin back on? I used contact cement for the flat piece oj bottom of bed. However, I went to put the nose piece on that folds fromt front down underneath the bed floor and didn't have as much luck. The cement was drying out by the time I got it folded under etc and I dont know that it will be strong enough to hold anyway. My next thought would be linoleum floor glue?
On a seperate note..... lol my wife had to run to Wal-Mart after her dr appointment so we drove separately. I asked her to pick up a new staple gun and some staples. She did and when I finally got around to using them this afternoon, she had picked up a new stapler and a pack of brad nails. Oops! Be the last time I ask my wife to do anything tool related! I dug out my old stapler and I was in luck.. still had staples in it! It's old and doesn't work right and wouldn't even kick one staple out. Lol oh well. I tried to use my air brad nailer to hold in place long enough to get aupport under it to hold the bottom bht they just didnt have enough head on them. So I didn't make much progress for the couple hours I had today. She has another appointment tomorrow morning and then I hope to get this thing in the dry tomorrow!
On a seperate note..... lol my wife had to run to Wal-Mart after her dr appointment so we drove separately. I asked her to pick up a new staple gun and some staples. She did and when I finally got around to using them this afternoon, she had picked up a new stapler and a pack of brad nails. Oops! Be the last time I ask my wife to do anything tool related! I dug out my old stapler and I was in luck.. still had staples in it! It's old and doesn't work right and wouldn't even kick one staple out. Lol oh well. I tried to use my air brad nailer to hold in place long enough to get aupport under it to hold the bottom bht they just didnt have enough head on them. So I didn't make much progress for the couple hours I had today. She has another appointment tomorrow morning and then I hope to get this thing in the dry tomorrow!
