Does the Onan Micro 40KY Generator slide out at all ?
How do u get at the fuel pump ? Will the assembly slide out a bit or drop down ? How do u get good access to the inside of the Generator ? ANy tips appreciated. Dave.
Forum Discussion
? Why you need to get to fuel pump?
When I replaced mine.
I had to remove it after removing the circuit board on left.
Remove fuel line first than metal connection on fuel pump. I needed a third hand. so had DW hold wrench on conn. from Gen. compartment. While used a deep socket to remove conn.
Not much room to work in. Make sure you use a gas proof sealant when putting it all back together. I did not and had to do second time. Real PITA.
No Gen slide. You can drop it. But a lot more stuff to disconn.
When I replaced mine.
I had to remove it after removing the circuit board on left.
Remove fuel line first than metal connection on fuel pump. I needed a third hand. so had DW hold wrench on conn. from Gen. compartment. While used a deep socket to remove conn.
Not much room to work in. Make sure you use a gas proof sealant when putting it all back together. I did not and had to do second time. Real PITA.
No Gen slide. You can drop it. But a lot more stuff to disconn.
