Dropping a gas tank
Well I started to drain the fuel tank to change the fuel hoses and the filler hose. While it's been draining I started to really look at the strapping and the bolts. Well I only have about 5/8" on eac...
Forum Discussion
My 90 GeorgieBoy Cruise Master was on the JohnDeere/Oshkosh chassis.( Ford 460) I lowered the 90gal. gas tank by using long sections of all-thread to replace the bolts, with washers and double nuts to support the tank. Used floor jack and 3/4 ply under tank.
I was able to get the tank below the frame and then tip the tank enough to replace the wires that the squirrels had eaten at the top of the tank.
Have seen several discussions on cutting a hole from above to get to the tank, I've not heard of any success. Most end up with a frame or obstruction in the wrong place.
Good luck...
I was able to get the tank below the frame and then tip the tank enough to replace the wires that the squirrels had eaten at the top of the tank.
Have seen several discussions on cutting a hole from above to get to the tank, I've not heard of any success. Most end up with a frame or obstruction in the wrong place.
Good luck...
