cancel
Showing results forย 
Search instead forย 
Did you mean:ย 

Norcold 1200 throws GFCI when starting

diplomatdon
Explorer
Explorer
Turned on the fridge for the 1st time this season, and it keeps popping the GFCI. All the electrical wiring and plugs seem good on the circuit, runs on LP but throws reset on AC. Could there be a problem with control board. Any help appreciated. Don
11 REPLIES 11

hanko
Explorer
Explorer
crasster wrote:
diplomatdon wrote:
Turned on the fridge for the 1st time this season, and it keeps popping the GFCI. All the electrical wiring and plugs seem good on the circuit, runs on LP but throws reset on AC. Could there be a problem with control board. Any help appreciated. Don


Could be a weak GFCI. I'd test it with several power tools, such as a drill, circular saw, and also perhaps a space heater. If GFCI trips, faulty plug.


Weak GFCI? its not a fuse
2014 Tiffin Open Road 36LA,Banks Power pack,sumo springs, 5 star tune, magnum invertor

2013 Ford Focus Toad

Haigh Superstar

hanko
Explorer
Explorer
I wouldt worry about doing away with the GFCI. especially on a frig.
2014 Tiffin Open Road 36LA,Banks Power pack,sumo springs, 5 star tune, magnum invertor

2013 Ford Focus Toad

Haigh Superstar

dougrainer
Nomad
Nomad
diplomatdon wrote:
Just a update on problem. Tried all the things mentioned as far as other appliances etc. causing problem. Not the issue. Tried new GFCI and not the problem. Would work if GFCI bypassed as Doug said, however the other plugs on the circuit not protected. We went away for a week, ran on LP. When we got home I checked the OHMS as Norcold Guy showed on his site. Resistance was within tolerance, put back together, plugged in and working fine. Guess it's good until the next time it happens. Don't know what the problem was but I claimed to the wife I fixed it. Thanks for every ones help and suggestions. Don


120 elements that trip GFCI will always OHM out correctly. One of the 2 elements is BAD, Period. I don't know who the Norcold Guy is, but I have 37 years of working on RV refers(always have fixed them). Doug

diplomatdon
Explorer
Explorer
Just a update on problem. Tried all the things mentioned as far as other appliances etc. causing problem. Not the issue. Tried new GFCI and not the problem. Would work if GFCI bypassed as Doug said, however the other plugs on the circuit not protected. We went away for a week, ran on LP. When we got home I checked the OHMS as Norcold Guy showed on his site. Resistance was within tolerance, put back together, plugged in and working fine. Guess it's good until the next time it happens. Don't know what the problem was but I claimed to the wife I fixed it. Thanks for every ones help and suggestions. Don

crasster
Explorer II
Explorer II
diplomatdon wrote:
Turned on the fridge for the 1st time this season, and it keeps popping the GFCI. All the electrical wiring and plugs seem good on the circuit, runs on LP but throws reset on AC. Could there be a problem with control board. Any help appreciated. Don


Could be a weak GFCI. I'd test it with several power tools, such as a drill, circular saw, and also perhaps a space heater. If GFCI trips, faulty plug.
4 whopping cylinders on Toyota RV's. Talk about great getting good MPG. Also I have a very light foot on the pedal. I followed some MPG advice on Livingpress.com and I now get 22 MPG! Not bad for a home on wheels.

P_Traveler1968
Explorer
Explorer
Probably the AC heaters but it actually could be any component that runs off of AC. Disconnect them and if it doesn't trip the GFI, that part is the root cause.

There are two heaters for the 1200. It looks like it's determined by the cooling unit serial number. MINE was completely unlegible but they were able to determine it for me by manufacture date. This should help:
***Link Removed***
http://thenorcoldguy.com/norcold-1200-1210-ac-heating-elements/

Probably important to mention that I had to use a rubber mallet to remove my old heaters from the heater slots on the flu. There is NO WAY I could have gotten them out with anything else.

vegasfoodguy
Explorer II
Explorer II
Old-Biscuit wrote:
Norcold 1200 has 2 (TWO) elements......225W each

Need to replace both.

Can be done from lower vent opening

Unplug leads on control module......pull elements up out of sleeves.
May need to wiggle back/forth to loosen

Small access door held in place via a tab. Bend tab then squeeze housing to unlock tab from door slot. Lift door slightly up and then out.


I was told, to Plug the the color leads in exactly where the old ones came out.
Monaco Diplomat, Cummins, 38a
Toad Grand Cherokee and Jeep Wrangler, Brake Buddy.

dougrainer
Nomad
Nomad
You can also attempt to get a NON GFCI plug to power the refer. This type trip is NOT a safety issue. Doug

PS, IF your unit is the 2001 Monaco, you may have a problem getting the old 120 elements out. If so, just do what I suggested above.

Old-Biscuit
Explorer III
Explorer III
Norcold 1200 has 2 (TWO) elements......225W each

Need to replace both.

Can be done from lower vent opening

Unplug leads on control module......pull elements up out of sleeves.
May need to wiggle back/forth to loosen

Small access door held in place via a tab. Bend tab then squeeze housing to unlock tab from door slot. Lift door slightly up and then out.
Is it time for your medication or mine?


2007 DODGE 3500 QC SRW 5.9L CTD In-Bed 'quiet gen'
2007 HitchHiker II 32.5 UKTG 2000W Xantex Inverter
US NAVY------USS Decatur DDG31

diplomatdon
Explorer
Explorer
Thank you Mr Wizard. Would have been much quicker and easier to post here than to try to troubleshoot no existent wiring issues. Will the fridge have to be pulled out or can the heating element be replaced from the vent opening. Thanks, Don.

MrWizard
Moderator
Moderator
Not the control board

the 120v heating element is leaking to ground

you will need to replace it with a new one

until then run the fridge on LP 'only'
I can explain it to you.
But I Can Not understand it for you !

....

Connected using T-Mobile Home internet and Visible Phone service
1997 F53 Bounder 36s