cancel
Showing results forย 
Search instead forย 
Did you mean:ย 

Rubber Membrane vs Fiberglass Roof

fbn_ent
Explorer
Explorer
I am still looking for a Class C and have found that the Forest River Sunseekers available used (rentals) have fiberglass roofs. Can you folks give me some input as to which is the best option? I would think that fiberglass is a big plus but I'm new to this world...:@
Thanks
22 REPLIES 22

Bumpyroad
Explorer
Explorer
10Grands wrote:
So what catagory does the TPO roof fall into, good / bad?


between rubber and fiberglass/aluminum. I would consider buying a unit with a TPO roof, wouldn't want another rubber one.
bumpy

10Grands
Explorer
Explorer
So what catagory does the TPO roof fall into, good / bad?

Jim_Shoe
Explorer
Explorer
I'd be more concerned about buying a former rental than worrying about the roof. Just think. Most of those renters have never driven an RV before. And some wouldn't admit to anything that didn't show when returning it. I know that I made some mistakes at first with my new 'C', and some of them were expensive.
Retired and visiting as much of this beautiful country as I can.

tom311
Explorer
Explorer
we are looking at sunseeker 2300 because its available on chevy and seems to be best made of the 3 brands on chevy.we like you want no slides,but for leaks possibilities but the stiffness of unit makes even more sense .

pnichols
Explorer II
Explorer II
For what it's worth, my 2005 Itasca's Class C brochure shows the same SuperStructure diagram, so Winnebago has been using that construction technique since at least 2005.

Also, we went for a no-slide model so as to help maintain coach framing stiffness and thus reduce coach structure stresses when on the tilted roads we run across when off the pavement rockhounding/exploring/fishing with our rig.
2005 E450 Itasca 24V Class C

tom311
Explorer
Explorer
Itasca sounds like certain models and floor plans?

pnichols
Explorer II
Explorer II
Desert Captain wrote:
Combine these features with all steel framing and you have one very well constructed coach.


What you're saying seems very similar to what Winnebago talks about they do here:

http://www.goitasca.com/key_features/2015/superstructure/
2005 E450 Itasca 24V Class C

Desert_Captain
Explorer III
Explorer III
tom311 wrote:
thanks for that information.all this helps us out.have to ask these things of sunseeker and nexus.it sounds from nexus video and looks like its one piece and goes over the sides.



We have a 2012 Nexus 23P and yes, the one piece fiberglass roof does go over the sides. Also the front and rear end caps are one piece and all of the windows have automotive seals. Combine these features with all steel framing and you have one very well constructed coach.

:C

tom311
Explorer
Explorer
thanks for that information.all this helps us out.have to ask these things of sunseeker and nexus.it sounds from nexus video and looks like its one piece and goes over the sides.

pnichols
Explorer II
Explorer II
All fiberglass RV roofs may not be the same.

You want one that's all one piece - instead of being flat fiberglass sheets with seams on the roof between the flat sheet edges.

You want a fiberglass roof that has a crown in it - not flat.

Also, you want one that has it's edges - at least all along the long side runs of the coach - rolled over 3 or 4 inches so no 90-degree seam is present right at the roof edge where rooftop fiberglass meets sidewall material.
2005 E450 Itasca 24V Class C

tom311
Explorer
Explorer
would the nexus or sunseeker be a better fiberglas roof construction?like all 1 piece.

mlts22
Explorer
Explorer
I miss the days of one piece aluminum roofs. I don't remember older trailers turning into scrap in five years due to water intrusion like ones made in the past decade tend to do.

The general problem is that unless properly engineered, the caulk in seams tends to be the only thing protecting against water intrusion, especially with water coming in at 70+ MPH while on the road. The two best cures are either the rvroof.com epoxy spray (so the roof is covered with a one piece coating), or if one does a good job (and this is not easy) of using Eternabond with all seams, making sure it is well pressed down and into place.

fbn_ent
Explorer
Explorer
WOW! Great info. Special thanks to ron.dittmer. The only MH I have had is my home built 30' Bluebird school bus and I inspected the additions (holes) in the roof often. (Call me paranoid!) I want to buy a used unit to be ready to go in late Feb / early March so I will be looking at quite a few. Have looked at e-bay but have an issue with travelling all over North America to view them....
I will definitely be having a close look at the Sunseeker that is available.

mobilefleet
Explorer
Explorer
I have an aluminum roof on my Telstar class c nearly 20 years old. No leaks