Winnebago 7 pin plug is there a charging line

There should be. It would be pin #4

Wiring

My 2014 Forza does have the charge line in place. However it is controlled by a relay and is only hot when the motor is running. Just make sure your Winnie and your toad have the charge line on the same pin on the connector.

Good Luck!

alkillion wrote:
My 2014 Forza does have the charge line in place. However it is controlled by a relay and is only hot when the motor is running. Just make sure your Winnie and your toad have the charge line on the same pin on the connector.

Good Luck!

Yes, I should have said in my post pin #4 if wired correctly.:B

Thank You

My 2008 Sightseer 29R on the F53 chassis didn't have a charging line on the 7 pin connector. Not only that, but the pin that one would normally use for it didn't even have a lug in it, it had a plastic dummy lug in its place. I didn't have any luck finding another 7 pin socket that was fully populated with all of the pins in it that would fit in the existing hole in the bumper so I used another unused pin to run a charging wire from the chassis battery to the towed with circuit breakers on each end. Perhaps they changed that on your newer model.I didn't have any luck finding the 7 pin connector on the Winnebago wiring diagram for for the 2011 Sightseer 35J. Good luck.
Al

On both of my Winnies, the 7 pin connector was not found on their wiring diagrams. The plug is provided by the chassis manufacturer so it can be found on the chassis diagrams, if you can find them.