Dish. Service. what are the steps when reconnecting
We have a houseboat. While tied on the dock I have a dish pointed that never has been moved in 6 plus years. We tie to the same position each time we go out an come in.
Problem when I go out off the dock I have a 2nd dish on and a rotary with its own hard wire.
Looking for the steps to use the 2nd dish.
I turn the power off the box. disconnect the cable incoming from the dock dish
Then Connect to the rotary mounted dish here is where I need help
( take for granted the dish is mounted level properly connected)
Do you turn an adjust the dish for the strongest possible signal at this point or use the remote an change it to find 110/ and or 119. When do I check switch. This is where I need help
I have learned a hard re set is often needed. But repeating set ups is from my lack of understanding. Any sites give u step by step thanks
I usually get everything up an working but feel I'm repeating some unnecessary steps
Problem when I go out off the dock I have a 2nd dish on and a rotary with its own hard wire.
Looking for the steps to use the 2nd dish.
I turn the power off the box. disconnect the cable incoming from the dock dish
Then Connect to the rotary mounted dish here is where I need help
( take for granted the dish is mounted level properly connected)
Do you turn an adjust the dish for the strongest possible signal at this point or use the remote an change it to find 110/ and or 119. When do I check switch. This is where I need help
I have learned a hard re set is often needed. But repeating set ups is from my lack of understanding. Any sites give u step by step thanks
I usually get everything up an working but feel I'm repeating some unnecessary steps
