I may have fried my Jack Antenna Please help
So I fired up my Jack Antenna this morning and auto programed the TV and every thing was fine. This afternoon I thought I would see what was on and got a no signal message from my TV I thought I might...
Forum Discussion
As stated NO LOAD voltage is always higher unless you have a really good regulated power supply. I doubt you fried the Jack.
Many reasons for "NO SIGNAL" could be a bad cable, low signal strength, if you are close to a station and know for sure you should have a signal you will have to check the voltage at the antenna to verify the wiring.
Not sure on your set up but do you have a switch ANT/CABLE in the wrong position?
Many reasons for "NO SIGNAL" could be a bad cable, low signal strength, if you are close to a station and know for sure you should have a signal you will have to check the voltage at the antenna to verify the wiring.
Not sure on your set up but do you have a switch ANT/CABLE in the wrong position?
