Jun-14-2023 02:12 PM
Jun-22-2023 01:31 PM
Jun-21-2023 12:42 PM
Jun-21-2023 07:43 AM
Boomerweps wrote:
For 30 amp service, use the rule of three, as in 3 is too much. AirCon, water heater, microwave. Use only two at a time. Often the three might play well together, but when you throw on another heating element of any kind (toaster, coffee maker, electric skillet) or the DC converter, it’ll often trip a breaker.
Jun-21-2023 07:34 AM
Samsonsworld wrote:Lantley wrote:Samsonsworld wrote:
All I can say is they were all turned to electricity. Whether they were all running, I never paid much attention to. But I don't go turn one off before turning another on, and I can't recall any issues. Believe what you want.
While I can't dispute your experience. It is not the norm. Typically you cannot just let those items run together without tripping a breaker on a 30 amp circuit.
Been going to the same state park for 25 years. The spots I like are 30amp. 5 different trailers, though only the last 3 had an electric water heater. Sounds normal enough to me.
Now throw in a hair dryer.....different outcome.
Jun-15-2023 05:52 PM
Jun-15-2023 03:30 PM
ktmrfs wrote:Samsonsworld wrote:
Dang, I think the microwave in my current unit is 700w. And I think my last two were 900w.
Might take 444 seconds for that meal.
and that is OUTPUT power, NOT input draw. a 900W microwave will draw around 1300VA they have terrible power factor and lots of power loss.[/quot
e]
Yeah, I don't know about that. A 1500 watt is about all a 16a breaker can handle. You're telling me its really over 2100w?
I tend to agree on the efficiency of an ac. That 12a (probably more like 14a) on the ac is start up surge. Probably runs at 7-8a. And cycles off to like 2a on the fan. Could be worse.
Jun-15-2023 03:05 PM
pianotuna wrote:Samsonsworld wrote:
Not everything turns on or surges at the same time. Its just not as big a deal as some make it out to be.
Mitch, 12a shocks me on the water heater. (edit: Yep, 1400w/120 = 11.6...most inefficient thing on there.)
"inefficient" resistance heat uses 99.9% of the energy.
Where one needs to worry is motor operated devices such as the horribly inefficient roof air conditioners. Below 107 volts there is ongoing cumulative permanent damage to the device.
If I'm in that situation I connect the autoformer. I've used it at an input voltage of 97 on a 15 amp circuit successfully. I did have to move the fridge to propane there were no other 120 volt loads except for the inverter charger. The house batteries were fully charged.
I do limit energy input to 24 amps using the inverter/charger and often have the load support feature active.
The largest load is the microwave at 1570 watts. I don't "cook" in it but do thaw home made meals. 222 seconds and my knife and fork are active.
Jun-15-2023 02:59 PM
Samsonsworld wrote:
Dang, I think the microwave in my current unit is 700w. And I think my last two were 900w.
Might take 444 seconds for that meal.
Jun-15-2023 01:48 PM
Jun-15-2023 01:15 PM
Jun-15-2023 11:57 AM
Jun-15-2023 11:07 AM
Samsonsworld wrote:
Not everything turns on or surges at the same time. Its just not as big a deal as some make it out to be.
Mitch, 12a shocks me on the water heater. (edit: Yep, 1400w/120 = 11.6...most inefficient thing on there.)
Jun-15-2023 09:15 AM
valhalla360 wrote:
What you describe will have peak loads well above 40amps.
Jun-15-2023 07:51 AM
Samsonsworld wrote:Lantley wrote:Samsonsworld wrote:
All I can say is they were all turned to electricity. Whether they were all running, I never paid much attention to. But I don't go turn one off before turning another on, and I can't recall any issues. Believe what you want.
While I can't dispute your experience. It is not the norm. Typically you cannot just let those items run together without tripping a breaker on a 30 amp circuit.
Been going to the same state park for 25 years. The spots I like are 30amp. 5 different trailers, though only the last 3 had an electric water heater. Sounds normal enough to me.
Now throw in a hair dryer.....different outcome.