Receiver pin holes out of round.
Hello everyone. I have a 2010 Chevy Silverado 1500 with a tow capacity of 9200 lbs. My trailer is a 31' Tracer Touring model lite. Empty, it is under 7,000 lbs. Loaded, at most would be less than 77...
Forum Discussion
I don't regret replacing the hitch after seeing the rust come out of it when I pulled it off. The hole is wearing down (6 O'clock), not towards the rear.
When I first hooked up this year, I noticed there was a little wear on the left side where the pin bends, and no wear on the side with the lock. After our last 1,000 mile trip, it was noticeable larger.
It's a done deal either way with the new Curt installed. Tomorrow I have to install the MaxAir vent covers that I never got around to do.
When I first hooked up this year, I noticed there was a little wear on the left side where the pin bends, and no wear on the side with the lock. After our last 1,000 mile trip, it was noticeable larger.
It's a done deal either way with the new Curt installed. Tomorrow I have to install the MaxAir vent covers that I never got around to do.
