50amp on 120/208 service
I know most systems are setup on 120/240 systems but I need to have a plug installed in a commercial building that has 3 phase lines coming in and power options are 120 and 208. I don't see where tha...
Forum Discussion
Bill.Satellite wrote:
We discussed the install and the installer was very familiar with an RV plug. I had just never seen the 208 setup and was looking for confirmation that using that was not a problem since I never use anything other than 120.
Since you have confirmed the electrician will properly wire the receptacle--
208 3 phase will yield the following in your situation--
208 volts across 2 hot leads
115 volts from each hot to neutral
This will work perfectly fine. You can and should confirm it with a volt meter. Good luck-- Mick
