5Amp Constant Current LED Driver
If anyone has any LED projects without on-board regulators, here's a cute 5A Constant Current/ Constant Voltage board I'm using for mine. So far I don't hear any RFI out of it, but will look on the an...
Forum Discussion
wa8yxm wrote:
5 amp is a lot to push through a LED less you are designing flash bulbs..And with multi-led Panels you would need matched led's and when one burns out the rest become flash bulbs.
But I see it is also a VOLTAGE regulator.. add a simple resistor and your LED's are very happy (one per led or with 5 volts one for every two led's).
its a constant current regulator, no need for him to use resistors, he can adjust current via a POT.
i like that both current and voltage are regulated. might pick one up for a project i got going with lipo
