Kiwkie step Model ? 1997 fleetwood bounder

No problem with controller and door switch

Just had to make sure I wired the motor to the correct polarity
To move the right direction

Everything working great

I'm a little late in responding but FYI, in 1999 Kwikee changed from a automotive windolift motor to the AM motor and a whole new gear box. Your controller should work fine but one ending in 10000 ithe most current.

Someone on here swears that the manufacturer sells seconds to LCI, not so. The motors are better than the ones that were used from 1995 to 1999.

You're on the right track and you may or may not have to change out the door switch.

old and new side by side


Click For Full-Size Image.

you can see the differences in the motor mounting screw positions and the gearbox design

this why, you have to replace both together, even if one of the old parts is good

at 22yrs age, best to replace both for $200 than just one piece at $80
now everything is new except the controller

the only problem is you don't get a power plug for the motor, but (2) butt splices trimmed and flatten on one end, then sealed with gasket or rubber sealer
makes a water/weather tight connection

I took the old gear box and motor out yesterday, going to put the new one in sometime today, " I hope"
Right now I'm getting ready to go over to the lock Smith, see what he can do with the tumblers and keys, in my door lock
Everything works from the inside, but the deadbolt won't lock with the key, and the door latch lock gets stuck and doesn't want to unlock with the key, took ten minutes to get in last night

Have pictures of the and and old gearbox and motor assembly's to post

I didn't look at the years. I'll have to remove those parts from my 95 Bounder, even though they work. Don't want the wrong year stuff on my coach. GRIN............

Richard

Thank you, I book marked the site
Says parts are for years 2000-2005

The new gearbox and motor arrived yesterday
Hopefully I can get them installed tomorrow/Thurs
If the weather forecast holds true

Pouring down rain right now

Series 32 linkage

Richard

I ordered the new gearbox and new motor, I know from doing the Safari, the mounts for the old motor and new Motor did not match, new gear box, new motor
Linkage not available for that model
At last I did not find it

Ball wobbles on the shaft, temporary repair, keep popping the clip off
Even after taking the time to make a good grove on the ball to hold the clip
Parts expected Tuesday
Have to wait a few days for dry weather, to install

Being you have 1997, if you don't have the updated electronic control box, (as Doug mentioned) you may have issues getting the new motor/gearbox to work properly with the old electronic control box and door switch.

Per the manufacturers recommendations:

I replaced my series 32 gearbox/control box (1999 model Series 32) and I bought the entire OEM update kit including the motor/gearbox, control box, fasteners, door switch, and wiring harness. Works like a charm, first time.

Chum lee

the bushing ? and snap ring that hold the 'curved' arm to the gear crank
are gone

the curved arm was/is attached to step pivot point, but not to the 'ball' on gearbox

i ordered the replacement gearbox and the motor, from amazon
lippert parts, not copied parts

same parts i put on the Safari feb 2015