Making a strong seam in galvanized sheet?
I'm making a thingy, and I thought one of you guys might be able to advise :B. .It's for a small garden bed. I want to take some 6 or 8" galvanised flashing and make a ring. The seam needs to be s...
Forum Discussion
BYU
Is obviously an expert :)
Naio when working with sheet metal WEAR GLOVES! Very Important.
If you decide to go the hole drilling, nuts and bolts route. After doubling both ends use Vise Grips and clamp tight. Nut & bolt after drilling then do the same for each hole. Old Mr. "One Hand" here has to try and outwit struggles.
Is obviously an expert :)
Naio when working with sheet metal WEAR GLOVES! Very Important.
If you decide to go the hole drilling, nuts and bolts route. After doubling both ends use Vise Grips and clamp tight. Nut & bolt after drilling then do the same for each hole. Old Mr. "One Hand" here has to try and outwit struggles.
