Power Plus Electric Leveling Jacks

my HWH jacks were biaxial or some such that they worked in pairs both for one side, or front or back to avoid twisting the frame. would suggest doing something similar, slowly working pairs to level off?
bumpy

Thank you for the replies, and sorry for taking so long to acknowledge them. I was supposed to get an e-mail notification but did not receive any.
Anyway, I was able to unplug the jack wires and I tested each jack individually with a couple of jumper wires. They did not seem to have much of a spark when I connected them, either down or up, so that told me the amp draw was not too drastic.
I have decided to use four DTDP momentary on switches and a standard off and on switch and make my own controller and run the jacks manually. The only problem I can see is I will have to be careful when retracting the jacks so as not to raise them to far, and to let go of the switch when they are all the way up.

Thanks again, Bob

for my boat anchor I just used a DTDP toggle switch with a jumper to reverse connections. I would "assume" the jacks would pretty much operate the same??????
bumpy

Depending on the current draw you might just use 4 simple up/down toggle switches.
Probably find a wiring diagram online.

If you will call me we can talk about it some more.
Just like Bumpy says it can be simple.