Slide out Adjustment

[Kjackson]

My slide out is a Lippert hydraulic unit, the problem I have is the bottom of the slide is out farther than the top. When I bring the slide room in the top comes in and stops while the bottom continues to move. I have read the adjustment manual but not sure which adjust ment to use, has anyone done this?

[Old-Biscuit]

Instructions to adjust slide IN & OUT positions.......LINK

[Kjackson]

When the slide is out the bottom on the inside is tight but the top leans in about an inch.

[Old-Biscuit]

Does it fully touch/seal top-sides-bottom when extended?

Does it fully touch/seal top-sides-bottom when retracted?

IF SO......nothing wrong

Both of my hydraulic slides do same.....top touches then bottom pulls in.
Slides are floor flush (ride up and over main floor when retracting)