breaks
i have never adjusted breaks on a tt how do i know they are tight enough and if i get them to tight how do i back them off
Forum Discussion
The way I do mine:
Jack the wheel off the ground.
Pry the rubber plug off the adjusting hole
Spin the wheel
Use a screw driver and turn the star wheel a notch or two, (look in with a flash light before you do it, so you can see what you will be doing)
Spin the wheel again if the wheel still turns easily, try it the other way.
Once you find which way tightens them, turn the star wheel until there is a slight drag on them, and then back the star wheel off until there is none.
Replace the rubber plug
jack L
Jack the wheel off the ground.
Pry the rubber plug off the adjusting hole
Spin the wheel
Use a screw driver and turn the star wheel a notch or two, (look in with a flash light before you do it, so you can see what you will be doing)
Spin the wheel again if the wheel still turns easily, try it the other way.
Once you find which way tightens them, turn the star wheel until there is a slight drag on them, and then back the star wheel off until there is none.
Replace the rubber plug
jack L
