Forum Discussion
Bob_Landry
Aug 03, 2010Explorer
The "A" frame wasn't wide enough to put two Gr27 battery boxes. This one is built out of 3/4" plywood, primed and sprayed with truck bed liner. The battery on/off switch is a Blue Sea. The hot wire for the break-away switch is wired directly to the battery so I can tow with the batteries off if I want to. I also cleaned up the factory wiring and put all of the exposed wires in loom. Not necessary, but it looks clean.
A Marinco Shore Power Inlet replaced the factory cover where you have to push a stiff cable back through the hole.
I also "T"d off the LP low side and ran a line to the side of the trailer for a gas grill. It has a cut-off and a quick-connect and a PVC cover that slips on to keep trash out of it. No photos on that one yet. Maybe this weekend.




A Marinco Shore Power Inlet replaced the factory cover where you have to push a stiff cable back through the hole.
I also "T"d off the LP low side and ran a line to the side of the trailer for a gas grill. It has a cut-off and a quick-connect and a PVC cover that slips on to keep trash out of it. No photos on that one yet. Maybe this weekend.




About Travel Trailer Group
44,026 PostsLatest Activity: Mar 03, 2025