Happijac motors
So one of my motors went out on my Happijac. After being told that it would work with the old motors I got two. One for the replacement and one to have on hand. It works well. It is quieter than t...
Forum Discussion
HMS Beagle wrote:bigfootgrey wrote:
I also spoke with Bigfoot Industries regarding the clearance issue for the new jack motors and they had to alter the jack mount to the swing out brackets to achieve clearance. This lowered the jack height to the road a few inches. Happijac says the new style motors are 8” above the top of the jack
I have a Bigfoot 10.4, 2008, same as you. I recently replaced the jacks with 4800, and at the time measured the motor clearance thinking I might need new motors. As I recall, I decided they would fit. My old motors still worked so I didn't change them. I'll measure them again but pretty sure you don't have an issue.
I replaced my front jacks with4800’s. The rear jacks are original 4150’s from 2008. If the clearance is ok for the fronts to swing in under the cab over that would be great. Does the control board need to be changed? Mine is original,with the cord.
