laj32 wrote:
I just recevied my
BAL 28050 about a week ago. It is Very Nice. Sturdy, uses a 3/4" wrench and is pretty "easy" to crank (little grease on the screw would help). I was able to slide it under the wheel and raise it a few inches without breaking a sweat (it was close though).
.
I used two of the BALs on my two axle trailer and they worked nicely and easily get you right on the money. The only things are that they're finger pinchers when handling if you're not careful and, depending on your tire diameter, can get bound up and difficult to remove on some soft ground. But all in all a satisfactory device.
To decrease effort consider using a socket and a long ratchet or breaker bar rather than the supplied wrench.