Low Converter Output

What model year is the travel trailer?

You have a converter/charger, not a pre-90's converter. Parallax is a converter/charger.

If there is only 4 volts, then yes the converter/charger is dead, and might not be able to be repaired. Check fuses first, and see if a GFI tripped inside the trailer to cause loss of power to receptacle that the converter is plugged into.

Plug something into the receptacle, and see if it works. If not, use a extension cord, or something to plug in the converter as soon as possible. The longer the battery is left below 12 volts, the more likely the battery will need to be replaced.

If you can not revive the converter right away, try using a portable battery charger. 10 amps will do something, even if it takes all day to charge it. 15 amps is better, and if you have one rated at 40 amps full time, it will also supply power to the lights while charging as well.

A 10 amp charger will charge the 105 amp hour battery in about 12- 15 hours. If you are using 4 lights during that time, it might take all night, but by morning (when the lights are normally off anyway) it should be full.

Good luck!

Fred.

Thanks for the advice. I think it's new converter time. I got the 4 volt DC reading with the battery disconnected and also at each 12V DC circuit on the panel, so it appears that I am indeed getting only 4V output. The converter is a Parallax 7155, and I see that direct replacements are available. It also appears that the 7155 is not a "smart" charger, so maybe I'll look for a better replacement. I will double check to see that I am getting 120V to the converter (not just to the main panel) in case there is a problem with the breaker.

Bill

Get a new converter but in the mean time, try to charge the battery with an external charger - but make sure you disconnect the battery from the RV first!
If the battery won't charge then you'll need to replace it too.
Don't take the chance of connecting the new converter to a shorted battery!!!

Saltworks wrote:


Any suggestions for solving this low output problem?

Bill

YEP.....new converter.

Best Converter......Ask Randy........LINK

4-5VDC is usually what a 12VDC battery reads when it has a shorted cell or two. It could be the converter may have boiled out your battery fluids over time and it has shorted internally. Check the battery for proper fluids and if that is normal then check for blown fuses or circuit breaker between the battery terminals and the converter terminal. There is also two REVERSE POLARITY fuses on the 12VDC distribution panel that may blow if the battery has a shorted cell in it or maybe occured when the battery was sparked good when inproperly connecting the terminals in reverse order.

Like said above with just the converter plugged in too 120VAC and not connected to the battery it will put out a constant 13.6VDC.

The two areas of concern here is the converter/charger unit and the batteries including the connection path between the two units.

Roy Ken

If you measuring converter output at converter level (vs battery) then you likely have bad converter - but if your measuring at battery I suggest you check around for nearby auto reset circuit breaker (Google for pic) which when blown cuts off converter from battery.

Bill, since the lights run off of the converter, are the lights at normal brightness when the trailer is on shore power?

Anything less than 13.2 is new converter time. Bench test before you spend money. You probably soon need a new battery too. Post the converter model for best replacement options. Do yourself and the battery a favor by getting a multistage converter.

Sometimes the connections for our converter seem to come loose or get corroded. I take them loose, clean the connections, put them back together and evrything is fine.

On our RV there is a small circuit breaker near the battery box. From time to time this trips and I have to push in a very small micro switch located on the circuit breaker to reset it. There are 3 circuit breakers one for each slideout and one for the converter.

The converter also has a reset button.

Your converter is probably dead. Call Best Converter and get a new converter. That's what I did when mine was reading 3 volts at the converter.