Terrible factory splices in brake wiring
OMG, I never would have thought splices in the brake wiring could be this bad. Am just replacing the backing plate assemblies on one axle. The first couple of splices I looked at were pretty bad...
Forum Discussion
About the only time I use solder is if I need to join 2 small wires to a larger one. I twist the 2 together and solder, then use a right-size crimp connector to join that joint to the other. Before I put the wires in, I fill the connector with silicone. After I crimp, (Use good crimp tool, don't just mash it) wipe off the excess. Strong, insulated, and sealed.
