msta999
Explorer
Joined 16 years ago
User Profile
User Widgets
All Activity
Re: 0020102 generac 4800 choke problem/water heater
Old-Biscuit wrote: Atwood G6A-7 Replacement Unit Atwood 96202 Atwood G6A-7 model replacement tank Atwood 91412 Good luck finding EITHER Dometic acquired Atwood several years ago and has stopped production/support for the 6 gal models They have a new 6 gal Dometic Model --- it is NOT a direct replacement for the Atwood 6 gal (Taller, narrower) Be easier to replace your 6 gal with a Suburban I have been looking, but like you said, they are hard to find! Looks like i may have found s replacement tank, but i have to call themp808Views0likes0CommentsRe: 0020102 generac 4800 choke problem/water heater
I noticed the connector with the two red wires, coming off the choke solenoid only has one red wire, i cant find the other one, i see the terminal in the connector......looks like the wire broke off it. If any of you can see yous, can you tell me where the small red wire goes?809Views0likes0CommentsRe: 0020102 generac 4800 choke problem/water heater
On mine there is just two small bolts that have to be loosened to adjust the choke to where you want it then retighten. Does yours have a bi metallic coil spring that activates the choke plate? Mine does have 2 small screws, I can only see the heads, that look like they are attached to the choke mechanism but I can't see inside the plastic housing and the choke does not move at all when cranking. I may have to take the cover off to see it, but it would be nice if I could find a manual for it.808Views0likes0CommentsRe: 0020102 generac 4800 choke problem/water heater
I did look at the generator last night and the choke linkage moves fine, looks like it is connected to a electric switch of some kind, but it is hard to get to, the housing the air filter goes in and the carb is bolted to needs to come off to see the switch. there was a cover over the linkage, that I took off and I have easy access to the choke lever, so I can start it easy from there. Anyone know here I can find a manual for this gen? I looked around for a water heater, but no luck, not even just the tank!808Views0likes0CommentsRe: 0020102 generac 4800 choke problem/water heater
It is a G68-7, 6 gal, made by Atwood. I did find one in canada, but it was over 400 USD and it wasn't clear if they had one or not. I also found they use to make replacement tanks, but it looks like it is all discontinued. I'll try lubing up the choke on the generator this weekend, once I pull off the air filter and such, I will have a better look at whats going on.808Views0likes0Comments0020102 generac 4800 choke problem/water heater
Last fall, when starting the generator, it had to crank a long time to start, so I performed a tune up, changed the oil and filter, air filter and fuel filter, when to start it and no change, looking at it I noticed the choke is not closing when cranking, if I manually close it it starts right a way, anyone use this type of generator? Ran across this problem before? I hope to dig into it more this weekend. Also, I didn't drain the hot water tank a two years ago and it burst, know where I can get a replacement? This is in a 24ft Carson Toy Hauler3.7KViews0likes12CommentsWhich TPMS system to buy for truck and trailer?
Hi all, I have an 05 F350 which I will be towing my 24ft toy hauler (double axle)and want to install an aftermarket TPMS kit to monitor tires on my truck and trailer. Anyone try'd any of these? Which kit will not have trouble communicating with the sensors on my trailer? Thanks and I hope everyone is doing ok and being safe!6.5KViews0likes33Comments
Groups
RV Newbies
We all start out new. Share lessons learned or first-time questions!Jun 15, 20174,026 Posts
