All ActivityMost RecentMost LikesSolutionsRe: Wandering Coach.08 .09 Positive toe after alignmentRe: Wandering CoachIt is my firstRe: Wandering CoachSoooooo. I found my alignment sheet that I got done last year. In referance to caster (mentioned earlier) caster range supposed to 5.0-7.0. Mine are in the red with 4.8, and 4.7. I remember the guy mentioning to me it would need some type of shim kit to get it in the range. He said it was close, and even on both sides and thought it would be good. Should I get them to do the shim kit and shoot for closer to the high end at 7 degrees.?? ThanksRe: Wandering CoachYes yes wandering. Thanks for the spelling lesson. It happens with no trailer, kinda wanders from side to side in the lane and I feel like I'm always steering it. Then when the trailer is hooked its transferred to the trailer and its swaying all over. All orignal shocks, but I did put new tires on and replaced the 10 suspension bushings in rear. 1999 holiday rambler, 40' with 350 cummins pusher.Re: Wandering CoachI though a lot about the trailer loading. But it does it empty.... Then it's just magnified because coach is wondering back and forth which jerks trailer around.Re: Wandering CoachI though a lot about the trailer loading. But it does it empty.... Then it's just magnified because coach is wondering back and forth which jerks trailer around.Wandering CoachJust wondering how I can improve the handling of my ride. 1999 holiday rambler, 40' 350 cummins diesel pusher 36000 miles. So while driving it just seems like I'm always chasing it, not terrible but always feel like I'm steering it. So here's the issue .... I bought it to tow my race car trailer with. So I have a 32' enclosed trailer attached. Soooo when I'm towing and chasing the motorhome, the trailer seems to all over the place. Wonder about shocks... Suspention bushings.... Alignment?? Something?Re: True cost to operate a DPWhat's a hydro hot service?Re: Have you bought a ten year old or older rv?About a year ago I bought a 1999 holiday rambler 40' with 350 cummins 36k miles, and yes there has been a few things I had to fix and work on BUT..... Im keeping for years and I would do it over again. Great buy for the $$$.Re: No heat/not turning onhttp://www.williamhendrix.com/Products.html Problem solved with the help of this guy. Bad comunication wire from zone 1 unit and the thermostat. I made a new cable and all works ....... furnace, and heat pump showed up. Also the units fired up..... Thanks guys Now I just have to run the new cable through ceiling and down the wall ... joys