All ActivityMost RecentMost LikesSolutionsRe: I like the Anza Borregomaybe he did Garcia,at least when you put it in 4wd,you knew it was in 4wd It is neat to go to a place that is the same after 52 years went to Pegleg monument and split mountain I like the Anza Borrego In 1962 my grandfather went camping here in a rig like this 52 years later visited the same places in a this rig Re: Where is everybody?I agree several of the post on the Truck Camper forum could have been posted here I used to enjoy the posts about best place in the boonies to see meteor showers The last one here was a bust because of the full moonRe: late Fall XTC tripAlways enjoy your posts We want pictures!!!Re: MH or TC - Which is better to get into the Boonies?Didn't see many class Cs last time I was in the boonies at Anza Borrego,unless they where towing a jeep and at a camping area. Re: New CampgroundDesigned for snowbirds who have to much money with taxes about $100 dollars CDN. The fine dining is the Mcdonalds and Arbys at the truck stopRe: Ford F250 Super DutyNot all F250s are created equal Camper pac,sno plow pac and regular pac. All have 10000 lb Gvw Only camper pac is rated for campers My snow plow pac had the same note in the glove box.It is 3200 payload with 4wd I got it because camper pac with 6.2 is hard to findfilling propane tanks in camper?A recent article in Mellow Mikes blog told about a bad problem that occurred while filling propane without removing them from a truck camper.I have always removed the tank. is this happening a lot? I think it is dangerous and the propane dealer should know better.I am not talking about the special horiz tanks but the standard 20lb tank.Re: Why a Truck camper? The best mobility you can get!I like the off road mobility Pic of my rig in Anza Borrego Re: Pop Up PU Camper tent material DaSu wrote: We bought a used Starcraft pop up pickup camper . I have noticed several times after I have raised the roof and the material spreads out , where it attaches to the roof part, the material comes loose from the groove that is suppose to hold it in .The material works it way out of the groove in some areas. All I have to do is work it back into the grove and it is back in place until next time . My question is this , is this material held in place by a clamping procedure or what? Have you ever had experience with this and if so how did you repair the problem Thanks in advance . Life is Good I had this problem on my Palomino,but it was made worse by the poor QC and strip of wood that held the grove was crooked and one of the screws came out and left a 1/4 inch gap in the right corner. repaired it once and now have to tear into it again.These things happen usually after warranty up.
GroupsBucket List Trips Bucketlist destinations you just can't miss. Which spots stick with you?Jan 18, 202513,487 PostsRV Newbies We all start out new. Share lessons learned or first-time questions!Mar 08, 20254,028 PostsTravel Trailer Group Prefer to camp in a travel trailer? You're not alone.Apr 19, 201944,027 Posts
Bucket List Trips Bucketlist destinations you just can't miss. Which spots stick with you?Jan 18, 202513,487 Posts
RV Newbies We all start out new. Share lessons learned or first-time questions!Mar 08, 20254,028 Posts