GPSTECH
Explorer
Joined 11 years ago
User Profile
User Widgets
All Activity
Re: Onan Microquiet 4000 "No Crank"
Model# 4kyfa26100k Spek k No idea on the hours The solenoid is good. When I apply 12v to the small terminal that is supposed to operate the solenoid it engages and the starter goes to working. Then if I push the start or stop button the fuel pump runs and it starts. However, when I release the button it dies I assume this is because the fuel pump stops.929Views0likes0CommentsRe: Onan Microquiet 4000 "No Crank"
There's not 12v to the starter. I can however jump the solenoid and it will spin over. Then if I hit the start button while its spinning over it will run. But when I release the start button it dies. I'm thinking some kind of control module or circuit board?928Views0likes0CommentsOnan Microquiet 4000 "No Crank"
My Onan will not crank. When pushing the button you hear the fuel pump kick in and the light flashes fast and constant. When you push the stop button you again hear the fuel pump kick in. Again this is a no crank condition, not a cranks and wont start. I jumped across the solenoid and it cranks but wont start unless I hold the start button or the stop button down. Then it will start and run as long as you hold the button down. Of course if you hold it down in the start position too long it will shut off and give you the over crank code. It will run as long as I want holding the stop button down but does not produce 120v while holding the button down. Any ideas?3.1KViews0likes10Comments
Groups
