Specifically the one in the middle. I'm not getting on the roof. I have no place I can park it under to reach it from above. I got to the outer ones fine with a ladder, but it's too far a reach from the sides. Can I lay a ladder on the front over the...
On my 1988 Southwind the driver side is leaking and wont pass inspection. I have a 1989 P30 factory service manual but it pretty much just says to remove spark plugs, remove exhaust pipe, remove manifold bolts and plug shields, remove manifold. I'm s...
On a 1988 Fleetwood Southwind. I removed the cable and can't get any movement from either end. The plastic cover looks fine. Trying to work some lube into the ends but not having any luck. Does anyone make a replacement cable?
Got a carburated '88 Southwind and I did a full service on it. New plugs, wires, cap, rotor, PCV valve, rebuilt the carb, new fuel filters, new fuel pumps. The spec calls for 4 before on the timing. When I checked it, it was at 16 before so I adjuste...
I changed all 5 brake hoses and will replace the master cylinder since it's cheap and I might as well since I have to bleed everything anyway. Is there some trick to bench bleed this thing? I can only get fluid flowing in one chamber. I installed it ...
Turns out those are the wrong gaskets. This manifold has round ports and those gaskets are oval. Looks like I need a Fel Pro 1412 or Mahle 95100SG. Any idea what heat riser gasket it would take? The distance between bolts is 3 9/32" and the hole diam...
Got it off today in less than an hour. Didn't bother using any fluid as it's mounted with bolts and no way to reach the threads behind the manifold. Bolts came out without any issue. Which gasket should I use? This metal GM gasket for about $20?Or th...
Not a fear of heights just don't like that there is no railing or anything on the sides. It's only 12 feet but might as well be standing on the ledge of a skyscraper. Might ask the place that did the inspection if they can replace it.
Gjac wrote:They are cast iron.I've never seen cast iron formed into tubular shapes like these, especially with that accordion section in the middle like that.
