All ActivityMost RecentMost LikesSolutionsRe: Winnebago access slide out issueThank you very much! I will try that and see what happens. It does act like they are out of Sync.Winnebago access slide out issueOk all, I know this topic is brought up many times but, I have an issue that has got me stumped. I have a 2008 Winnebago Access class c. The living room slide out stops about 3-4" short of extending all the way out. The slide has 2 electric motors that power it. One odd thing I did notice the last time I tried it the battery was low on the coach and it went out very slowly but it extended all the way which seems odd to me. Any other time I always leave the coach running when I extend the slide. I also always make sure I am level. I should add this is a power gear FLS Digi sync system. Thanks in advance for tips or adviceRe: 2008 winnebago access slide not working??Ok everyone let me update you.... Tonight I went out and manually cranked slide out. I was able to get the touch pad to go into manual mode and the slides came in. That immediately told me I have power to the slide. However the slide would not go out still flashed parking brake light. So I manually cranked slide out again. Running out of ideas I decided to push parking brake all the way down to the floor. What do you know the slide came in like it should, and now goes out like it should. I had ruled the parking brake out do to the rear slide working. How ever the parking brake sends two separate signals to two separate controllers. I could make it not work by not pushing brake all the way down. I never would have guessed that the brake would need pushed all the way down but it worked. Thanks to everyone who offered suggestions and happy camping!Re: 2008 winnebago access slide not working??.Re: 2008 winnebago access slide not working??Yes emergency brake is set. Back slide works fine. Front slide switch panel flashes the parking brake light but I know it is set properly since the back slide worksRe: 2008 winnebago access slide not working??Thanks for the reply. I have ruled out the switch panel itself. My slides are on to separate switch panels and I swapped them and it was no change. I have chased wires and checked grounds all seems to be good. Any ideas where the control module may be located. I have heard those to give problems as well. Im not sure how to reset the system?? Thanks again. Ill take any help I can get!Re: 2008 winnebago access slide not working??Thank you. I guess its time to start chasing wires. I tried switching out controllers and its the same deal so I have ruled that out.2008 winnebago access slide not working??Hi all, Just recently purchased 2008 Winnebago access bunk house. Living room slide worked fine over the weekend camping and now will not work. The red parking brake light on the switch panel flashes but the parking brake is set. The rear slide works no problem. Any ideas and suggestions would be greatly appreciated!Class C bunkhouseHi all new to the forum. We are currently looking into getting our first class c. We really like the bunkhouse set up and are currently looking at a 2008 winnebago access. I also found a 2010 four winds bunkhouse but can't find much info on them. Any other brands you all like and dislike? Looking to not go newer than 2008. Thanks in advance