Ford's answers to the NHTSA 6.7 Investigation
There was a request for a link to Ford's answer's to the NHTSA investigation posted on a previous thread, since closed. Here is the link: Ford's NHTSA Answers to the 6.7 investigation This PDF i...
Forum Discussion
The question is why is water not a big deal with CP3 (1600 bar) and now a huge issue?
What is the phenomena that made it a big nail for the OEMs
If ASTM spec is for .05% water by volume, then in actual use, measured in tank, with heated fuel recirculated, is not .1% (2X) reasonable?
150liters or so a tank (not nominal, but fully filled)
1/10th of 1 pct .15 liters.
That is well within the water separator to hold... if it is not emulsified.
What is the phenomena that made it a big nail for the OEMs
If ASTM spec is for .05% water by volume, then in actual use, measured in tank, with heated fuel recirculated, is not .1% (2X) reasonable?
150liters or so a tank (not nominal, but fully filled)
1/10th of 1 pct .15 liters.
That is well within the water separator to hold... if it is not emulsified.
