3d printed water fill adaptor
I use my 3d printer to create accessories and replacement parts. I designed a water fill adaptor so that the water hose wont keep falling out as I fill the fresh water tank. If you have a 3d printer, ...
Forum Discussion
JimBollman wrote:
I have tried to talk myself into a 3D printer for a few years now but so far have resisted. I have enjoyed the design process and discussion.
I have used the same simple filler adapter for years it has lasted at least the last 4 campers. $6 on Amazon.
I don't even use that, just put the end of the garden hose into the hole. goes in about an inch, then gently turn on the hose till it is going pretty good. never had it blow out yet. but I do think I'll print one of these adapters .
Steve
