3d printed water fill adaptor
I use my 3d printer to create accessories and replacement parts. I designed a water fill adaptor so that the water hose wont keep falling out as I fill the fresh water tank. If you have a 3d printer, ...
Forum Discussion
LittleBill wrote:
stove pipe it. extend your hose filler, put a t between the hose and the filler, add about 4 inches, then you can drop the pellets from above and let the water push it in.
ya that seams a heck of a lot easier than trying to shake a bunch of pellets in then wasing them down rince and repeat haha
