safe/temp portable sat mount on roof ideas

That mount is designed for the specific foot pattern of the X1 and is not compatible with the X2. However, that does not mean you might not be able to jury rig that base to hold your X2. It will likely involve using the existing "tent stake" holes in the base and running some cords in, under and around that ladder mount base. The other initial problem you will encounter is that the Pathway X2 is substantially larger and will likely not fit between the arms of the ladder so it will have to be mounted pretty high (if that's possible). Let us know if you have any luck but that's an expensive experiment. Maybe you can return it if you can't find a way to make it work.
A couple of bungees and the ladder would likely work just as well.

Just looking at pictures I am not sure why this is only listed for the X1. But I would try making this work vs taking a chance on damaging my roof.


https://www.amazon.com/Winegard-MT-4000-Pathway-Satellite-Antennas/dp/B01EYGL1OY

Years ago I made a mount out of PVC and would bungie it to the roof ladder. Worked great and never moved.

So, I have it mounted on one of the slides, strapped so it won't move... but I think I need just a little more height so I'm going to use a couple boards, strapped down to the center air, then plant the dome on that and screw it down to the boards so it can't blow off... it'll take a couple days.

Bill.Satellite wrote:
The OP was asking about mounting a dome, not a tripod.

Would you like me to draw a dome instead of a tri pod??? Either way what I drew would work just fine.

Still waiting an answer what was so wrong with my option.

Just looked it up, I would NOT consider it a DOME.

The OP was asking about mounting a dome, not a tripod.

Look on the internet there are several examples of antennas using a flagpole mounted to the rear ladder and the antenna is attached to that. Just another option.

B.O.

Bill.Satellite wrote:


I would never recommend anything even close to that being mounted on the roof of an RV. However, that's the great thing about an open forum, all opinions (constructive) are welcome.

Maybe you could say WHY You would not???

Here is my reasons how it would be perfectly acceptable.

The 2x’s would support over several roof trusses and the rubber Matt would keep them from damaging the roof. This is basically how a dish is added to a flat roof on a commercial building. The cinder blocks would keep everything solid.

Cummins12V98 wrote:
The OP has a "ROUNDED" roof.

I would lay a heavy rubber matt down. I would Male an assembly from 2x4's that allows for a couple cinder blocks on each side.

Sumpin like this.

I would never recommend anything even close to that being mounted on the roof of an RV. However, that's the great thing about an open forum, all opinions (constructive) are welcome.

Off to Lowes sometime today. We'll see how it goes. Thx for advise.