furnace burner goes off then on
I have a 2000 Snowbird with an Atwood Mobile 8535-IV-DCLP furnace. When operating the burner will burn for awhile then stop then start again, and continue this pattern until it reaches temperature. Th...
Forum Discussion
Not normal at all. Sounds like perhaps an overheat sensor is cutting the burner off even though it hasn't reached the temperature required. As it cools a little, the sensor allows it to go again.
Check it out carefully for plugged air flow perhaps, bad sensors, or a slow fan.
Check it out carefully for plugged air flow perhaps, bad sensors, or a slow fan.
