Propane detector squealing

Well, after reading thru the comments I guess I need to check mine as it is 11 years old and has not made a sound yet. It was powered up Sunday when I was in the trailer looking for something.

MFL wrote:


Another consideration, is detector location. It needs to be in best area, and the right distance from the floor.

Jerry

A good point for the OP - who seems to be "new" to propane detectors -

Since propane is heavier than air.......

the "right distance" is close to the floor, and NOT "upstairs" in the bedroom!...:W

~

I replaced mine with same as original. They are not cheap, but easy to replace. I think mine was just under $100 from Amazon. You want one that runs on battery power, live all the time.

Mine was one day past the date marked on back, when it started going off every once in a while. Even though my FW is a 2012, the date on the detector was 2010. The new one has yet to go off, other than when I hit test.

Another consideration, is detector location. It needs to be in best area, and the right distance from the floor.

Jerry

Although the propane detector appears to be working fine now, advice from other posters has convinced us to replace it. Our 5th wheel is a 2008 Jayco Eagle Superlite. Would you suggest we use a plug in replacement or should we find one that wires in like the present one?

My LP alarm doesn't like extreme heat (just like me) and it goes off on summer days when the trailer is closed up. I reset it and open the door for awhile and it stays off til the next blistering day. It's also probably due to be replaced. Craig

Old-Biscuit wrote:

Endricken wrote:
FYI
My OEM Detector lasted 5 years. Replacement has just turned 5 years old and has started going off occasionally. Will order a new one soon.
Perhaps their lifespan is associated with being "ON" (Battery power on) and we're practically fulltimers so maybe that's why our detectors lifespans are nominal vs. longer.

Most are wired directly to battery bypassing disconnect switch ......parasitic draw.....so they are always ON

:h :S

Guess it sould be called only a partial disconnect switch!!

I installed my own, directly in the positive side of the battery.

I've had a build up of dust set off smoke detectors but not sure if the same would set off propane detectors.

Endricken wrote:
FYI
My OEM Detector lasted 5 years. Replacement has just turned 5 years old and has started going off occasionally. Will order a new one soon.
Perhaps their lifespan is associated with being "ON" (Battery power on) and we're practically fulltimers so maybe that's why our detectors lifespans are nominal vs. longer.

Most are wired directly to battery bypassing disconnect switch ......parasitic draw.....so they are always ON

FYI
My OEM Detector lasted 5 years. Replacement has just turned 5 years old and has started going off occasionally. Will order a new one soon.
Perhaps their lifespan is associated with being "ON" (Battery power on) and we're practically fulltimers so maybe that's why our detectors lifespans are nominal vs. longer.

rockhillmanor wrote:
Just to be on the safe side, CHECK your stove knobs to make sure they didn't get bumped to the on position. Been there done that.

I know the OP has already ruled this out, but I wanted to make a comment.

Several years ago I was sitting by the fire mid-day, when the trailer my sister-in-law had rented started beeping like crazy. Good thing the trailer was unlocked.

I shut off the stove, aired out the trailer. They returned from the pool none the wiser.

yes....someone must have leaned on it.