Repairing holes in walls or mollys for tv mount

One solution for cover up the oops could be the tape that is used to cover adjoining sheets of luan wall panelling *if* you can get in a matching color. The tape is about an inch wide.

One easy way to find the backers is by using a magnet. Some folks have used a piece of wood, plywood or even sheet metal to span a couple of studs. You may not have studs if you have a fiberglass sided FW tho.

I like RV Oscar rivets for securing heavy things. They're a type of blind rivet and have a high holding power. They'd work if you use a piece of sheet metal on the wall and then rivet that to the wall and mount the TV to that. Just paint the sheet metal a color of your choice to blend in.

What you do will depend on the size and weight of the TV and whether or not you're using an articulating mount.

If no one has suggested it yet, have you considered toggle bolts? They're the ones with the butterfly wings that pop open behind the wall when you insert them into the wall.

Generally, if you want to mount a TV to a bedroom wall, there will be a specific place marked for doing so. Might have to call the mfr with your VIN to get that, but I've seen a =lot= of RVs that have a sticker on the wall saying "TV Mount Here". G*d forbid that they mount one at the factory.

Lyle

If you are useing metal mollys be sure to use ones for thin walls. You will see two holes on the shoulder of molly there is a small tool with two tips to go in the holes to keep the molly from spinning, if you do not have the tool use needle nose plyers.

https://www.fastcap.com/product/fastcap-peel-and-stick-cover-caps
if you decide to cover try this.

My wife put a little pressure on the shelf along side our bed and it pulled the screws through the 1/8" paneling. I thought it was ridiculous that there was no backing where they mounted stuff. I don't know if there is any hardware that would support a TV on that thin paneling.

Check out the Togglers by Hilti. I buy them by the box of 100 but maybe you can find them or something similar at a hardware store. The advantage of Togglers over Mollys is that the screw can be removed without the fixture falling behind the wall. I use them to mount grab bars in bathrooms. The disadvantage is that the wall has to be at least 1/4 inch thick.
The holes can be filled with something called Patch and Prime. A mesh patch is put across the hole and the spackle covers it up. No priming needed. Just paint over it.
Maybe just a visit to an Ace hardware store would give you more ideas.

It is very simple to put pictures into your post on these forums.
To post photos do the following:

1. Upload your photo, one at a time, to this site.

2. Copy the resulting URL.

3. Paste the URL directly into your post with NO modifications. Do not add or subtract anything from the URL.

Your picture will then appear in your post and be properly sized for use on these forums. Do the same for each additional photo.

You just Upload, copy, and paste.
If you would like to practice doing that, just go to this thread that I started in the DIY forum to try out the app.

This app was developed by one of our own moderators to simplify the posting of pictures. All that needs to be done is upload your picture to our site, then paste the resulting URL into your posts.

Could not be much more simple to do than that! :) You don't even have to worry about the size of the photo as the software will re-size it to our forum recommendations.
Barney

Johno02 wrote:
Post a picture of what you have, and we will recommend a fix.

How can I upload it (I only see an option for a storage link)?
Would you guys recommend a spray foam in the hole and then to cover it with wood filler?

Can anyone recommend a type of Molly that has worked so I don't have to patch these and then create new holes?

Post a picture of what you have, and we will recommend a fix.